Is it ever OK to exceed the speed limit?
Is it ever OK to exceed the speed limit?
According to the California basic speed law, drivers cannot exceed a safe speed for the current road and weather conditions.
Who has the right away when turning left on a solid green light?
If you’re turning left at a green light, pull out into the intersection but wait to turn left until all oncoming traffic has passed. If you’re turning left at a four-way stop or uncontrolled intersection, you should give the right-of-way to any oncoming drivers going straight, even if you got there first.
What is a protected left turn?
The protected left turn phase provides a green arrow for left turning vehicles while stopping both on-coming traffic and parallel pedestrian crossings to eliminate conflicts. This option may be appropriate where left turn traffic volumes are relatively manageable but opposing through volumes are relatively high.
How many feet should you signal before making a turn?
100 feet
When you enter traffic from a stop you?
When crossing or entering city or highway traffic from a full stop, signal, and leave a large enough gap to get up to the speed of other vehicles. You must share the space with traffic already on the road.
When a traffic light turns green should you go immediately?
GREEN—A green light means GO, but you must first let any vehicles, bicycles, or pedestrians remaining in the intersection get through before you move ahead. You can turn left ONLY if you have enough space to complete the turn before any oncoming vehicle, bicycle, or pedestrian becomes a hazard.
When changing lanes you should never?
Check for other drivers moving into the same lane. You should never change lanes within an intersection. Before changing lanes, always look over your shoulder to check your blind spot. Be alert to other drivers moving into the same lane.
Is pass to the left a firm rule?
If the vehicle ahead of you is turning left. A. Wrong because “pass to the left” is a firm rule.
At what speed should you pass another vehicle?
It varies, but sometimes, when overtaking another car, you are allowed to exceed the speed limit by 10-15 mph. Typically, this applies to two-lane highways where the posted speed limit is 55 mph or higher.
How do you know if the master cylinder is bad?
5 symptoms of a bad master cylinder
- Abnormal brake pedal behavior.
- The brake warning light comes on.
- Low brake fluid level.
- Depressed/sinking brake pedal.
- Contaminated brake fluid.
- Park on level ground.
- Look under the hood.
- Start the engine.
Can brakes fail then work again?
It is rare to change the brake master cylinder as part of what is commonly called a “complete brake job.” As a result, it is possible for the brake master cylinder to fail even after you’ve just had a “complete brake job.”
How do you fix brake failure?
If your brakes suddenly fail, do the following:
- Downshift to low range (labeled as 1) in case of automatic transmission and low gear in manual transmission.
- Pump the brake pedal fast and hard to build up brake fluid pressure.
- Apply the parking brake, but be ready to release it if the car begins to skid.
Why did my brakes suddenly stop working?
This can be due to a number of problems: a leak in a brake line, a loss of pressure within the master cylinder itself due to a failed seal, or air being introduced into the braking system. Your first reaction to encountering spongy brakes should be to rapidly pump the brake pedal with your foot.
How much does it cost to fix spongy brakes?
How much does it cost to fix soft and spongy brakes? The cost to repair a soft, spongy, or mushy brake pedal depends on the underlying cause. Based on U.S. pricing trends before discounts, bleeding or flushing the brake fluid will cost $70-$110, and fixing a brake fluid leak or master cylinder will cost $100-$300.
Is it safe to drive with a soft brake pedal?
If your brake pedal feels soft or ‘spongy’ stop immediately and get a breakdown mechanic to check the car. Driving with a ‘soft’ brake pedal is extremely dangerous because your brakes could fail at any moment, even if they don’t fail they will be inefficient, possibly leading to an accident.
How much does a complete brake job cost?
A complete brake repair — one that includes pads, rotor and caliper replacement — typically averages between $300 and $800. However, depending on the make and model of your vehicle, you can easily spend more than $1,000 on a complete brake job.
Why do my brakes feel spongy after bleeding them?
The most common cause of spongy brakes after bleeding, is contaminated brake fluid. Usual contaminates include air or moisture in the system. Most common causes, include: Brake bleeding technique.
